![]() I can move the arm all around so it's close enough to what I'm doing without being in the way. I'm thinking that I can use a hole saw to cut half circles into a board that can keep the tools from rolling around. I plan on putting a box on it to hold 5 or 6 turning tools. I bought a articulating arm for a TV that mounts to the wall. ![]() Let us know what you think once you have it set up. I'm not a big fan of harbor freight but their tools have a place. It has no problem holding the 40lb grinder with no flex. It's 17" by 18" but you could easily add a wood top to it. You probably could do the same thing and put your lathe on the side tray. I ended up putting a couple tack welds so now it's no longer folding. The side tray is pretty strong but the design has the support leg just resting in a shallow pocket. I put my Tormek clone grinder on the stand at 30" (the cart is 42" with the lid closed. I got the larger one, I think they call it the '5 drawer' because the side tray was beefier and larger. I went with the mechanic's cart so I could add the side tray. The 46" width may be too long for you as well. Not sure if that would be too high (you could remove the wheels to make it lower but loose being able to roll it across your shop). I looked at it but it was locked so I could open the doors to look at the shelves. It has a wooden top, one large drawer, and shelves behind a pair of doors. I was debating between it and the 46" Yukon mobile workbench. So on Monday I stopped by Harbor Freight and picked up a "mechanics cart". I thought about making something but finding time is always an issue and the scrap pile of hardwood that I would of used I've been saving for making segmented bowls. But I did want a cabinet of some sort to put the various stuff that's been building up as I buy more and more tools and supplies. My lathe is on legs so I didn't need a table to put it on. Also I suspect materials would wind up costing as much or more than other options. This seems like a good way to get exactly what I want, but also would take a lot of time that could be used doing either more fun projects or more lucrative ones. It seems like the shelves would be constantly buried in chips. A shop built stand with open shelving.Has anyone here done that? How did it work out? A used kitchen cabinet maybe from the Habitat for Humanity Re Store.So storage for lathe tools in the stand would be a big plus. In addition to my hobby turning, my shop is a low production shop for a hobby luthier business and right now my table saw out feed table is covered with lathe tools. It works okay as far as supporting the lathe, but falls short in tool storage (there is none), chip management (a plastic tub under it), and a place for my vacuum pump (it sits on the floor right now). I started out with a quick open stand made with 2x4s and splayed legs. I am pondering a new stand for my little 10 x 18 lathe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |